Difference between revisions of "R-Mobile/Boards/KZM-A9-GT"

From eLinux.org
Jump to: navigation, search
(Initial KZM-A9-GT page)
 
(Add Remote Control)
Line 30: Line 30:
 
bootz
 
bootz
 
</pre>
 
</pre>
 +
 +
== Remote Control ==
 +
 +
{| class="wikitable"
 +
|-
 +
|'''Operation'''
 +
|'''Signal A'''
 +
|'''Pin A'''
 +
|'''Signal B'''
 +
|'''Pin B'''
 +
|'''Connector needed'''
 +
|'''Comments'''
 +
|-
 +
|Reset
 +
|JTAG nSRST
 +
|CN1 pin 15
 +
|GND
 +
|CN1 pin 16
 +
|2-pin female Mini-PV
 +
|nSRST is an 1.8V signal!
 +
|-
 +
|Wake-Up
 +
|NMI
 +
|SW6
 +
|GND
 +
|SW6
 +
| -
 +
|Needs soldering
 +
|-
 +
|}

Revision as of 02:08, 22 September 2017

Kyoto Microcomputer Co. KZM-A9-GT

Introduction

This is the Wiki for the Renesas SH-Mobile AG5-based Kyoto Microcomputer Co. KZM-A9-GT board. Refer to the R-Mobile page for information about Renesas' SH-Mobile SoC family.

Serial Console

Use a mini-USB cable to connect to "CN22". Serial settings are 115200 8N1.

Booting Linux

 * Kernel config: shmobile_defconfig
 * Kernel image: arch/arm/boot/zImage.dtb
 * DTB: arch/arm/boot/dts/sh73a0-kzm9g.dtb

Create a zImage with appended DTB:

make zImage dtbs
cat arch/arm/boot/zImage arch/arm/boot/dts/sh73a0-kzm9g.dtb > arch/arm/boot/zImage.dtb

U-Boot boot command:

tftp 0x43000000 kzm9g/zImage.dtb 
bootz

Remote Control

Operation Signal A Pin A Signal B Pin B Connector needed Comments
Reset JTAG nSRST CN1 pin 15 GND CN1 pin 16 2-pin female Mini-PV nSRST is an 1.8V signal!
Wake-Up NMI SW6 GND SW6 - Needs soldering