Difference between revisions of "RZ-A/Boards/RZA2MEVB"

From eLinux.org
Jump to: navigation, search
(Added new page)
 
(fixed typo)
 
Line 18: Line 18:
 
  $ ./build.sh jlink dtb
 
  $ ./build.sh jlink dtb
 
  $ ./build.sh jlink xipImage 0x20200000
 
  $ ./build.sh jlink xipImage 0x20200000
  $ ./build.sh jlink axfs 0x20800000
+
  $ ./build.sh jlink rootfs_axfs 0x20800000
  
 
* Boot Linux using the follow command in u-boot
 
* Boot Linux using the follow command in u-boot

Latest revision as of 04:48, 6 November 2018

Renesas RZ/A2M Evaluation Board

Rza2mevb.jpg




Quick Instructions

  • Clone the BSP from github and build an XIP kernel
$ git clone https://github.com/renesas-rz/rza_linux-4.19_bsp.git
$ cd rza_linux-4.19_bsp
$ ./build.sh config rza2mevb
$ ./build.sh buildroot
$ ./build.sh u-boot
$ ./build.sh kernel xipImage
  • Use J-Link to program the board
$ ./build.sh jlink u-boot
$ ./build.sh jlink dtb
$ ./build.sh jlink xipImage 0x20200000
$ ./build.sh jlink rootfs_axfs 0x20800000
  • Boot Linux using the follow command in u-boot
=> run xha_boot



NOTE: Make sure the SW6 switches on the base board match what is displayed when u-boots.

                ON     SW6
                +---------------------+
                |       = = = =       |
                | = = =               |
                | 1 2 3 4 5 6 7 8 9 0 |  Please make sure your sub-board matches
                +---------------------+  these switch settings.
       SW6-1 set to Other
       SW6-2 set to Audio
       SW6-3 set to USB, CAN, UART(console)
       SW6-4 set to Ether1
       SW6-5 set to Ether2
       SW6-6 set to VDC6
       SW6-7 set to VDC6