Tadpole Lure

From eLinux.org
Revision as of 14:38, 24 March 2015 by Prpplague (talk | contribs) (Description)
Jump to: navigation, search

Tadpole Lure on MinnowBoard Max

Description

The Tadpole Lure is a low cost "Mini-Lure" design that providing a single RGB LED and a breakout/prototype area.

Components

Tadpole Components










Design Files

The Tadpole Lure is an "Open Source Hardware" compatible device and is licensed under Creative Commons Attribution-ShareAlike 3.0 United States (CC BY-SA 3.0)

Oshw-logo.png



Assembly

Getting Started

Getting Started

To assemble the Tadpole Lure, a soldering iron (15Watt to 30Watt), some solder, and a pair of wire cutters.







R1 12 Ohm Resistor

12 Ohm Resistor

There is a single resistor with the color code BROWN-RED-BLACK. This one is used for the resistor position marked R1.







R2/R3 68 Ohm Resistors

68 Ohm Resistors

There are two resistors with the color code BLUE-GREY-BLACK. These are used for resistor positions marked R2 and R3.







R4/R5/R6 4.7K Ohm Resistors

4.7K Ohm Resistors

There are three resistors with the color code YELLOW-VIOLET-RED. These are used for the resistor positions marked R4, R4 and R5.







RGB LED

RGB LED Alignment
RGB LED

The single RGB LED in the kit is mounted with the longest lead as the second hold from the side with a flat edge. The LED package has a flat side. The flat side is matched up with the white line marking on the PCB.










Transistors

Transistors

Three 2N3906 PNP transistors are included with the kit. Each transistor is mounted on the PCB with the flat side of the transistor matching the markings on the PCB.







Connector

Connector

The 2 row by 13 pin connector is mounted to the bottom of the PCB. The connector has a piece of plastic marking the "key side". The "key side" of the connector points to the outside of the PCB.







Completed

Completed