View source for Talk:R-Car/Boards/Salvator-X

Jump to: navigation, search


Thread titleRepliesLast modified
Failed to DRAM initialize003:15, 10 October 2019
Flashing of the Salvatore-X with poky images000:35, 26 June 2017
About contribution of a question106:44, 30 September 2016

Failed to DRAM initialize


I followed the Yocto build and flashing procedure for H3 Salvator-x. However I get the following problem. I enabled some debug messages in boot_init_dram.c

SW7 is set to ‘cold boot’ It seems to fail the pi_training_go() test

[ 0.000169] NOTICE: BL2: R-Car Gen3 Initial Program Loader(CA53) Rev.1.0.21 [ 0.005745] NOTICE: BL2: PRR is R-Car H3 Ver.3.0 [ 0.010421] NOTICE: BL2: Board is Salvator-XS Rev.1.0 [ 0.015542] NOTICE: BL2: Boot device is HyperFlash(160MHz) [ 0.021063] NOTICE: BL2: LCM state is CM [ 0.025110] NOTICE: BL2: AVS setting succeeded. DVFS_SetVID=0x53 [ 0.031093] NOTICE: BL2: CH0: 0x400000000 - 0x480000000, 2 GiB [ 0.036964] NOTICE: BL2: CH1: 0x500000000 - 0x580000000, 2 GiB [ 0.042849] NOTICE: BL2: CH2: 0x600000000 - 0x680000000, 2 GiB [ 0.048733] NOTICE: BL2: CH3: 0x700000000 - 0x780000000, 2 GiB [ 0.054659] NOTICE: BL2: DDR3200(rev.0.33)NOTICE: Start [ 0.060116] NOTICE: init_ddr:0 [ 0.073840] NOTICE: init_ddr:1 [ 0.075791] NOTICE: init_ddr:2 [ 0.078615] NOTICE: [COLD_BOOT]NOTICE: init_ddr:3 [ 0.084204] NOTICE: init_ddr:4 [ 0.087476] NOTICE: init_ddr:5 [ 0.089849] NOTICE: init_ddr:6 [ 0.093275] NOTICE: init_ddr:7 [ 0.544304] NOTICE: ..1 [ 0.545360] NOTICE: BL2: Failed to DRAM initialize (-1). [ 5.007803] ERROR: [ 5.008597] ERROR: BL2: System WDT overflow, occurboot_init_dram.ced address is 0xe6312d78

Kind Regards, Declan

03:15, 10 October 2019

Flashing of the Salvatore-X with poky images

Hi I'm trying to figure out how to flash the Salvatore-X board (with H3 SiP), it seems I can't find any instructions specific to these boards, are the instructions for Premier and Pro boards, more or less valid? If not how to do it? Is there any recovery procedure if Mini-Monitor is destroyed?

00:35, 26 June 2017

About contribution of a question

No one seems to be contributing. Should a question be contributed here?

Is it limited to a question in English?

03:37, 30 September 2016

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Users.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page.

Return to Thread:Talk:R-Car/Boards/Salvator-X/About contribution of a question/reply.