Difference between revisions of "Template:FLYSWATTER2 BEAGLEBONE CONNECT"
| Line 11: | Line 11: | ||
==Connect the 20 Pin Ribbon Cable to the Flyswatter2.== | ==Connect the 20 Pin Ribbon Cable to the Flyswatter2.== | ||
| − | [[File:fs2_20pin_ribbon.jpg|left]] Connect one end of the 20-pin end ribbon cable to the Flyswatter2's JTAG interface. | + | [[File:fs2_20pin_ribbon.jpg|left|250px]] Connect one end of the 20-pin end ribbon cable to the Flyswatter2's JTAG interface. |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Revision as of 12:04, 10 April 2013
Contents
- 1 Connecting the Flyswatter2 and the BeagleBone
- 1.1 Requirements
- 1.2 Connect the 20 Pin Ribbon Cable to the Flyswatter2.
- 1.3 Connect the 14-pin Ribbon Cable to the JTAG Adapter Board.
- 1.4 Connect the 10-pin Ribbon Cable to the RS-232 Adapter Board.
- 1.5 Connect the Other End of the Ribbon Cable to the Beagleboard XM.
- 1.6 Plug in the Serial Cable.
- 1.7 Connect the USB cable to the Flyswatter2.
- 1.8 Connect the Power Cable to the Beagleboard XM.
- 1.9 Plug the Power Adapter into a Wall Outlet.
- 1.10 Plug the USB Cable into your PC.
Connecting the Flyswatter2 and the BeagleBone
Requirements
To hook up the Flyswatter2 and the BeagleBone, you will need:
- Installation of the Alternative JTAG Header on the BeagleBone
- 20-pin JTAG Ribbon Cable
- ARM20 to CTI20 Adapter
- USB Mini-B Device Cable
- 5V1A Power Cable
Connect the 20 Pin Ribbon Cable to the Flyswatter2.
Connect one end of the 20-pin end ribbon cable to the Flyswatter2's JTAG interface.
Connect the 14-pin Ribbon Cable to the JTAG Adapter Board.
Your cable most likely has a notch on the head to force it into the correct position. If it doesn't, align Pin 1 on the ribbon cable with the side of the board opposite the EMU pins. (In the picture, Pin 1 is marked by the red stripe on the cable.)
Connect the 10-pin Ribbon Cable to the RS-232 Adapter Board.
Connect the Other End of the Ribbon Cable to the Beagleboard XM.
Be sure to align the ribbon cable correctly. Pin 1 on the Beagleboard XM is the pin closest to the center of the board.
Plug in the Serial Cable.
Connect the Flyswatter2 and the Beagleboard XM with the RS-232 serial cable.
Connect the USB cable to the Flyswatter2.
Find the USB cable that comes with the Flyswatter2. Connect the B end (the square end, not the flat end) to the Flyswatter2.
Connect the Power Cable to the Beagleboard XM.
The Beagleboard XM's power adapter is next to the serial port.
Plug the Power Adapter into a Wall Outlet.
The green power LED on the Beagleboard XM should come on and remain on.
Plug the USB Cable into your PC.
The green power LED on the Flyswatter2 should come on and remain on.
