Template:FLYSWATTER2 PANDABOARD CONNECT

From eLinux.org
Revision as of 17:36, 17 April 2012 by Wmat (talk | contribs) (Porting TinCanTools wiki content.)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Connecting the Flyswatter2 and the Pandaboard

To hook up the Flyswatter2 and the Pandaboard, you will need:

  • 20-pin ARM to 14-pin TI JTAG Adapter Board
  • 14-pin JTAG Ribbon Cable
  • RS-232 Serial Cable with one male, one female head
  • USB Male A/Male B Cable
  • 5V1A Power Cable

Set the EMU pins on the JTAG Adapter Board.

Ti adapter.png

The EMU0 and EMU1 pins should be set to 1. Set both jumpers to the position closest to the 14-pin interface, as in the picture.


Connect the JTAG Adapter Board to the Flyswatter2.

Fs2 ti adapter.png

Connect the 20-pin end of the adapter board to the Flyswatter2's JTAG interface.


Connect the 14-pin Ribbon Cable to the JTAG Adapter Board.

Fs2 ti jtag.png

Your cable most likely has a notch on the head to force it into the correct position. If it doesn't, align Pin 1 on the ribbon cable with the side of the board opposite the EMU pins. (In the picture, Pin 1 is marked by the red stripe on the cable.)


Connect the Other End of the Ribbon Cable to the Pandaboard.

Fs2 panda jtag.png

Be sure to align the ribbon cable correctly. Pin 1 on the Pandaboard is the pin closest to the center of the board.


Plug in the Serial Cable.

Fs2 panda bothcables.png

Connect the Flyswatter2 and the Pandaboard with the RS-232 serial cable.


Connect the USB cable to the Flyswatter2.

Fs2 panda usb.png

Find the USB cable that comes with the Flyswatter2. Connect the B end (the square end, not the flat end) to the Flyswatter.


Connect the Power Cable to the Pandaboard.

Fs2 panda power.png

The Pandaboard's power adapter is next to the USB and ethernet ports.


Plug the Power Adapter into a Wall Outlet.

The green power LED on the Pandaboard should come on and remain on.

Plug the USB Cable into your PC.

The green power LED on the Flyswatter2 should come on and remain on.