image for IDP JTAG Lure needs to be refreshed

Jump to: navigation, search
Revision as of 30 April 2015 at 14:36.
The highlighted comment was created in this revision.

as it doesn't match the current design files (per Revision A2). And, in particular, because it appears that the orientation of the Samtec BSH-030 is not correct on the Revision A1, at least per the image shown!

Note also, that IDP is not a conventional term of art - I believe that it should read as ITP (for in-target probe).

    Aley asset (talk)

    ‎07:07, 30 April 2015

    wait a minute! a closer examination of Revision A2 doesn't look right either!

    per the prints and footprints at https://www.samtec.com/technical-specifications/Default.aspx?SeriesMaster=BSH: 

    - PDF File  BSH - .5mm (.0197") Basic Socket Strip
- PDF File  BSH - Surface Mount Footprint

    shouldn't the alignment pins be on the pin-2 side?!

      Aley asset (talk)

      ‎07:36, 30 April 2015
       
      Retrieved from "https://elinux.org/Thread:Minnowboard_talk:MaxLures/image_for_IDP_JTAG_Lure_needs_to_be_refreshed"