BeagleBone Black Rev B6 - USER LED's will not turn on at all when trying to boot from SD / USB
← Thread:Talk:BeagleBone Black Extracting eMMC contents/BeagleBone Black Rev B6 - USER LED's will not turn on at all when trying to boot from SD / USB/reply
You do not have permission to edit this page, for the following reasons:
- The action you have requested is limited to users in the group: Users.
- You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.
You can view and copy the source of this page.
@Cjohnweb -- FAT32 worked for me (formatted from a Windows 7 virtual machine).
Initially, I had many failed attempts when I tried to extract the eMMC image. I tried different types of FAT file systems, using different OS's to perform the format, marking the card as 'active' or 'bootable', copying the files to the card in a specific order (so the MLO and u-boot.img files were first in the file allocation table), all to no avail. Eventually, I discovered you have to hold the S2 button while power is applied, and then release the button a few seconds later. Holding the S2 button and pressing RESET did NOT work for me. Holding the S2 button for too long also does not work (the board just turns off).
It all seems painfully simple in hindsight, but when I first read this Wiki article it didn't say anything about the S2 button, and nothing I tried worked. Even when I was holding the S2 button, I was just pressing RESET, which also doesn't work.
Hopefully this helps!