Firmware update hangs

Jump to: navigation, search
Revision as of 5 June 2017 at 10:30.
The highlighted comment was created in this revision.

I got a new WS1.1 Premier starter kit, tried to build 2.19.0 but the kernel was crashing.

Tried to upgrade the firmware, but it failed to download bl2 srec. Now, it is not even booting into u-boot.

I tried downloading the firmware from windows PC (Teraterm) and Linux (minicom), boot params is getting programmed. I can't program none of the other firmware as given in the instructions.

Either it hangs after sending the file (bl2, bl32, cert), or over size error (uboot)

Any inputs to recover the board is welcome.

    09:41, 31 May 2017

    Address of bl2 has been chenged from Yocto v2.17.0. Please check the following page. http://elinux.org/R-Car/Boards/H3SK#Flashing_firmware

      18:39, 4 June 2017

      yeah, following the exact instruction in your link. After downloading the bl2 the mini monitor is stuck.

      I see that the board can boot into SCIF download, is it possible recover the board by this route?

        02:30, 5 June 2017