Firmware update hangs
Fragment of a discussion from Talk:R-Car/Boards/Yocto-Gen3
← Thread:Talk:R-Car/Boards/Yocto-Gen3/Firmware update hangs/reply (2)
← Thread:Talk:R-Car/Boards/Yocto-Gen3/Firmware update hangs/reply (2)
yeah, following the exact instruction in your link. After downloading the bl2 the mini monitor is stuck.
I see that the board can boot into SCIF download, is it possible recover the board by this route?
I've attached the my log.
H3 SAMPLE LOADER V1.16 2016.10.24
CPU : AArch64 CA57
DRAM : LPDDR4 DDR3200 DEVICE: QSPI Flash(S25FS128) at 40MHz DMA
BOOT : Normal Boot
Backup: DDR Cold Boot
jump to 0xE6330000
H3 MiniMonitor V0.23 2016.10.24
Work Memory SystemRAM (H'E6328000-H'E632FFFF)
>
>
>xls2
===== Qspi/HyperFlash writing of Gen3 Board Command =============
Load Program to Spiflash
Writes to any of SPI address.
Please select,FlashMemory.
1 : QspiFlash (U5 : S25FS128S)
2 : QspiFlash Board (CN2: S25FL512S)
3 : HyperFlash (SiP internal)
Select (1-3)>3
READ ID OK.
Program Top Address & Qspi/HyperFlash Save Address
===== Please Input Program Top Address ============
Please Input : H'e6304000
===== Please Input Qspi/HyperFlash Save Address ===
Please Input : H'40000
Work RAM(H'50000000-H'53FFFFFF) Clear....
please send ! ('.' & CR stop load)
H'00040000-0007FFFF Erasing..Erase Completed
SAVE SPI-FLASH....... complete!
======= Qspi/HyperFlash Save Information =================
SpiFlashMemory Stat Address : H'00040000
SpiFlashMemory End Address : H'0005B03B
===========================================================
>
If you don't solve it please attach your log.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page.
Return to Thread:Talk:R-Car/Boards/Yocto-Gen3/Firmware update hangs/reply (4).
